Dhcp; Dhcp Settings - TP-Link TL-WR810N User Manual

5.8 DHCP

Figure 5-17 The DHCP menu
There are three submenus under the DHCP menu (shown in Figure 5-17), DHCP Settings,
DHCP Client List and Address Reservation. Click any of them, and you will be able to configure
the corresponding function.

5.8.1 DHCP Settings

Choose menu "DHCP → DHCP Settings", and then you can configure the DHCP Server on the
page as shown in Figure 5-18. The Router is set up by default as a DHCP (Dynamic Host
Configuration Protocol) server, which provides the TCP/IP configuration for all the PC(s) that are
connected to the Router in the LAN.
 DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must
have another DHCP server within your network or else you must configure the computer
manually.
 Start IP Address - Specify an IP address for the DHCP Server to start with when assigning
IP addresses. 192.168.0.100 is the default start address.
 End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP
addresses. 192.168.0.199 is the default end address.
 Address Lease Time - The Address Lease Time is the amount of time a network user will
be allowed connection to the Router with their current dynamic IP Address. Enter the
amount of time in minutes and the user will be "leased" this dynamic IP Address. After the
TL-WR810N 300Mbps WiFi Pocket Router/AP/TV Adapter/Repeater
Figure 5-18 DHCP Settings
- 114 -