Inserting The Gas Cartridge - DeWalt DDF5110500 Manual

English
Connecting the Charger:
Î
Connect the power cord to the adapter (1).
Î
Connect the battery charging cable to the
charging unit (2).
Î
Connect the power cord to the power supply
(3).
Î
Put the battery into the charger (4).
4
Charging the Battery:
The charger indicates the current charging
status:
green red
LED LED
On Off
Off On
On Off
Flashing Flashing
On On
Flashing On
42
2
3
1
Status
Charger ready/operational
Battery is charging
Battery fully charged
Battery is overheated:
Remove the battery from
the charger and let it cool
down.
Battery is defective:
Remove the battery from
the charger and never use
it again.
Battery is defective and
overheating: Remove the
battery from the charger
and never use it again.
After the battery is fully charged:
Î
Insert the battery into the Gas Nailer or
protect it from short circuits using the
protective cap.
Î
Disconnect the power cord from the power
supply (pull the power plug).

3.2 Inserting the Gas Cartridge

WARNING
Serious injuries due to accidental
triggering
Î
Remove the battery.
Î
Do not press the barrel of the Gas
Nailer against any surfaces.
Î
Keep your ¿ nger away from the
trigger.
Î
Observe the safety instructions, see
chapter 1.6 "Gas Cartridge".
Î
Press the safety button on the cover/lid (1)
and then open it (2).
2
Î
Remove the depleted gas cartridge (if
present) and insert the new one.
1