Lubrication; Fuses - Stiga PARK 4WD PRO 25 Instructions For Use Manual

EN

5.13 LUBRICATION

All lubrication points in accordance with the table
below must be lubricated every 50 hours of opera-
tion as well as after every wash.
Object Action
Wheel 2 grease nipples.
bearing Use a grease gun filled with univer-
sal grease. Pump until the grease
emerges.
Centre 4 grease nipples.
point Use a grease gun filled with univer-
sal grease. Pump until the grease
emerges.
Steer- Brush the chains clean with a wire
ing brush.
chains Lubricate with universal chain spray.
Ten- Lubricate the bearing points with an
sioning oil can when each control is acti-
arms vated.
Ideally carried out by two people.
Control Lubricate the cable ends with an oil
cables can when each control is activated.
Must be carried out by two people.

5.14 FUSES

If any of the faults listed below occurs, replace the
relevant fuse. See fig. 27.
Fault
The engine does not start or starts and
stops immediately. The battery is charged.
Sand spreader and electrical cutting height
adjustment do not work.
All electrical functions are out of opera-
tion. The battery is charged.
6 PATENT - DESIGN
REGISTRATION
This machine or parts thereof is covered by the fol-
lowing patent and design registration:
SE9901091-0, SE9901730-3, SE9401745-6,
US595 7497, FR772384, DE69520215.4,
GB772384, SE0301072-5, SE04/000239 (PCT),
SE0401554-1.
72
ENGLISH
Fig.
28
28
-
29
30
Fuse
10 A
20 A
30 A
GGP reserves the right to make alterations to the
product without prior notification.