Preparing Your System - Keurig Rivo Use And Care Manual

PREPARING yOUR SyStEM
Prepare the Water Reservoir
STEP 1:
Rivo ™ System and Frothing Pitcher. Place the System on
a flat, stable surface away from water and heat sources.
Remove all adhesive tape and labels.
STEP 2:
remove the Water Reservoir by lifting up and away from
the Rivo
STEP 3:
We recommend bottled or filtered water.
Hot water or any other liquid may damage the Water
Reservoir. Always ensure the Water Reservoir is filled to
the REFILL line before turning on the Rivo
Prepare the Brewing System*
STEP 1:
Cord into a grounded outlet and press the Power Button on
the right side of the System.
STEP 2:
and you will hear a beep. this indicates the Rivo
is ready. Press the Espresso Lungo Button to run the first
cleansing brew. When brew is complete, discard the hot
1 Min
water from the mug.
Remove all packing materials from the Keurig
Lift and remove the Water Reservoir Lid, then
System.
™
Rinse the Water Reservoir and fill with water.
System.
™
Place a 12 oz. mug on the Drip tray. Plug the Power
After about 1 minute, the Control Panel will flash
System
™
8
Prepare the Frothing System*
STEP 1: Remove packing material and static cling from
®
Frothing Pitcher and fill to MIN FILL with water. Secure
the Lid and place the Frothing Pitcher into the System.
STEP 2: Press the Latte Froth Button to run the first
cleansing froth. you will hear a beep when the cycle
is complete.
STEP 3: Remove the Frothing Pitcher from the System
and carefully remove the Lid. Discard the water and dry
all components.
*The first cleansing brew and cleansing froth cycles prepare the
System for your first beverage. It is normal for the System to be
slightly louder during these initial cycles.
*After brewing, the Rivo
for your next brew. As a safety feature, your System will
automatically shut off at any stage when it is idle for longer
than 2 minutes. Press the Power Button to restart.
You are now ready to craft your
System will automatically prepare
™
first beverage!
9
1 Min