Rimage Everest 600 User Manual page 25

Maintaining the Everest 600 Printer
1. Access the print head.
a. Press the two side cover latches to release the side cover.
b. Lower the side cover.
c. Open latch 1.
d. Remove the print ribbon carrier. For specific instructions, refer to
the Change the Print Ribbon
2. Clean the print head.
Caution! Do not scratch the print head. Remember the following
n
tips:
• Always wipe from one end of the print head to the other without
stopping in the middle.
• Only wipe the area indicated.
a. Apply isopropyl alcohol to the sponge swab.
Print Head Area to Wipe
Roller
2001474_B
procedure on page 17.
Wipe
Direction
For more information visit
b. Use the sponge swab to wipe across the print head from one end to
the other in the direction shown.
c. Repeat as needed until the print head is clean of dust and debris.
d. Use the sponge swab to remove any waxy buildup from the roller
below the print head.
3. Prepare the printer for use.
a. Install the print ribbon. For specific instructions, refer to the
the Print Ribbon procedure on page 17.
b. Install the print ribbon carrier.
c. Close all latches.
d. Close the side cover.
The printer is ready for use.
Clean the Tacky Rollers
Tools required:
#
• Sponge swabs with long handles (included in the Everest
cleaning kit)
• 99% Isopropyl alcohol
1. Remove the print ribbon. For specific instructions, refer to the
the Print Ribbon procedure on page 17.
rimage.com/support
Change
Change
Print Ribbon Carrier
Tacky
Roller 1
22