Optional Glass Surround Installation - Regency PTO30-NG1 Owners & Installation Manual

installation
|
22

OPTIONAL GLASS SURROUND INSTALLATION

OPTIONAL GLASS SURROUND/WINDSHIELD INSTALLATION
Overall Dimensions: 37-15/16" long x 12-13/16" wide x 5-5/16" high
1. Remove metal fasteners from the corner brackets.
2. Assemble the 4 pieces of the glass surround/windshield and fasten
together with 4 corner top brackets and supplied nylon fasteners as
shown below.
3. Using a flat screwdriver, secure 4 top corner brackets with nylon
fasteners in each corner, bracket should be flush with the top of glass
as shown below.
4a. After the 4 top brackets are installed - flip over and place on a soft
surface, to install the 4 bottom brackets.
22 |
Regency Plateau® PTO30-1 Outdoor Gas Fireplace
919-037
PTO 30-1
Part No. 376-932
4 Piece Glass Surround
Overall Dimensions: 68" long x 12-13/16" wide x 5-5/16" high
4b. Use supplied spacer tool to determine where the bottom bracket
should be placed and secured.
Nylon fasteners
5. Secure bottom corner brackets with nylon fasteners in each corner.
6. Flip the glass back over and place on a soft surface. The glass is now
right side up. The glass should be raised up 1/2" in bracket as shown
below.
7. Place assembled glass surround/windshield on table top - ensure glass
is centered on the table top. Once in correct position, lift up one end,
apply double sided tape that has been cut to size, to the bottom of the
brackets. Repeat process on other end. Press down firmly from to
secure glass surround/windshield in position. Use care not to scratch
surfaces.
1
OUTDOOR SERIES
PTO60-1
Part No. 377-955
Bottom Bracket
Top Bracket
Insert nylon fastener
Nylon fasteners
1/2"
Spacer tool
here.
10/30/14