Glass Crystal / Basalt Volcanic Stones Installation - Regency PTO30-NG1 Owners & Installation Manual

GLASS CRYSTAL / BASALT VOLCANIC STONES INSTALLATION

Evenly spread the Glass Crystals and optional Basalt Volcanic Stones over the burner. Ensure the crystals (or stones) do not overlap too much as this will
effect the flame pattern.
IMPORTANT NOTE:
Only the supplied approved Glass Crystals and Basalt Volcanic stones are to be used with these fireplaces. Use of any other type of glass crystals or stones
can alter the unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.
When using Basalt Volcanic Stones DO NOT cover pilot light that lead to pilot flame.
Unit
PTO30
PTO60
NOTE: * Glass Crystals are available in 1lb and 5lb bags.
¹ Glass Crystals to be installed on the burner prior to installing stones.
Basalt Volcanic Stones are measured by weight not quantity. Each bag contains 15 lbs of stones, however the exact quantity
and size vary. Sizes vary between 2" - 3"
3. Work Crystals downwards to front
edge of top edge of burner.
NOTE: Correct final glass installation of Crystals as shown in step 2 and 3.
The Burner should not be visible when the flame is out.
NOTE:
Basalt Volcanic Stones are NOT to be placed anywhere on the Pilot assembly area.
Glass Crystals to be installed on the burner prior to installing stones.
BURNER PACKAGES
Glass Crystals Only *Glass Crystals + Volcanic stones¹
10 lbs 5lb glass + 1 box stones- recommended
20lbs 10lb glass + 2 boxes - recommended
1. Start pouring Crystals on one end of
the burner.
4. Basalt Volcanic Stones shown
spread evenly over the burner and
crystal base.
2. Work Crystals to other end of the
Burner. Base and burner tube
should not be visible when crystals
are spread out.
5. Ensure Crystals do not block the
front of the pilot hood and flame to
light the burner.
Regency Plateau® PTO30-1 Outdoor Gas Fireplace
installation
e |
|
19
19