Pto60 Assembly - Regency PTO30-NG1 Owners & Installation Manual

installation
|
14

PTO60 ASSEMBLY

NOTE: PTO60 is two PTO30 units assembled end to end. You must pur-
chase two PT030s to make a PTO60.
1 Remove the large stand off on the end of the unit from both PTO30 units
- by removing 2 screws per side.
Large standoff
2. Remove 9 screws in locations shown below to remove burner tray (re-
move from both units).
3. Lift burner tray off-burner tube can remain in place.
14 |
Regency Plateau® PTO30-1 Outdoor Gas Fireplace
4. Line the two units up end to end. Screw fireboxes together (one from
each side).
5. Reinstall burner trays.
6. Install units together into framing (refer to framing section). Secure in
place with nailing strips.