Shindaiwa BP530 Operator's Manual page 20

Before you start
Assembly of the handle
1. Square nut
2. Barrier
Cutting attachment shield assembly
1. Socket-head cap
Screw
2. Bracket
3. Shim
4. Clamp screw
5. Outer tube
1. Cutting attachment
shield
2. Hook receiver
3. Handle
4. Bolt
6. Cutting attachment
shield
7. Shim
8. Cutting attachment
shield mounting plate
9. Retaining nut
3. Sub-shield
4. Hook
1. Put the 4 square nuts into the frame of barrier.
2. Fit the handle and barrier over the outer pipe and tighten the
4 bolts.
3. Position the handle at the best position?for operator comfort.
4. Secure the handle by alternately tightening the four bolts in
a diagonal or "crisscross" fashion.
Cutting Attachment Shield
1. Insert the cutting attachment shield between the outer tube
and the cutting attachment shield mounting plate.
NOTE
It may be necessary to loosen the retaining nut and clamp
screw to adjust cutting attachment shield mounting plate.
2. Fit the two shims and the bracket over the outer tube and
loosely install the four socket-head cap screws.
3. Tighten the four socket-head cap screws to secure the cut-
ting attachment shield.
Make sure the clamp screw and retaining nut are securely
tightened before tightening the four socket-head cap
screws.
Sub-shield (when trimmer head is in use) (Consult
your dealer.)
1. Attach the shield extension to the cutting attachment shield.
Never use this product without sub-shield when using a
trimmer head.
Make sure the sub-shield is completely hooked at the
hook receiver.
18
CAUTION
WARNING
CAUTION