Using 5 Mm X 20 Mm Fuses; Replacing The Fuse Holder - Kurzweil PC3x Service Manual

Using 5 mm X 20 mm Fuses

1. If you use 5 mm X 20 mm fuses, install them toward the inside end of the fuse holder near
the metal pins.
2. The photo below shows the correct position for a 5 mm X 20 mm fuse.

Replacing the Fuse Holder

1. Insert the fuse holder into the power entry module. The indicator showing the desired
voltage should be positioned toward the outer edge of the module away from the power
switch.
2. Close the fuse holder cover.
3. Check the voltage indicator and verify the desired voltage is present in the window.
4. The unit is now ready for operation.
5. Be sure to connect the correct power cord to match the current voltage.
Troubleshooting & Maintenance
Converting the Voltage
4-21