Closing The Pc3X - Kurzweil PC3x Service Manual

Disassembly/Assembly
Opening the PC3x

Closing the PC3x

Warning: The following procedure assumes that you have completed Steps 3 and 4 in Replacing
the Top Enclosure. If you have not completed these steps, do so before continuing.
1. Refer to Figure 3-1. Tilt the unit up and install the four enclosure support wall screws.
Note: In addition to the rear panel screws, the endcap locking bracket secures the endcap to the
top enclosure. When the endcap locking bracket is in position, it rests against the endcap
clamping bracket located on the underside of the top enclosure. See Figure 3-5.
2. Slide one side of the unit off of your work surface and hold the appropriate endcap and
3. Install the endcap locking bracket screw in the bottom enclosure.
4. Install the three remaining endcap screws in the bottom enclosure.
5. Repeat for the other endcap.
6. Refer to Figure 3-3. Install the four endcap screws in the rear panel.
3-6
Endcap Clamping Bracket
Endcap Locking Bracket
Figure 3-5 Top enclosure, endcap locking and clamping brackets
endcap locking bracket in position.
Endcap Screws