Installing Microsoft Windows 2000 Operating System - NEC EXPRESS5800/120Re-2 Service Manual

Installing Microsoft Windows
System
Use the following procedure to set up and perform a clean Windows 2000
Operating System installation on your server.
1. Insert the Windows 2000 CD into the CD-ROM drive and boot your system
by pressing CTRL+ALT+Delete.
Note
installed in your server; go to Step 7 if your server does not
include a RAID controller.
2. While the message "Setup is inspecting your computer's hardware
configuration" or a solid blue background is displayed on the screen, press
the F6 key.
Note
the F6 key has been pressed.
3. When the following message is displayed, press S.
"Setup could not determine the type of one or more mass storage devices installed in
your system, or you have chosen to manually specify an adapter". Currently, Setup will
load support for the following mass storage devices.
4. When the following message is displayed, select Other then press Enter.
Select the SCSI Adapter your want from the following list, or select "Other" if you have
a device support disk provided by an adapter manufacturer
5. Insert the "Windows 2000 OEM-DISK" diskette into the floppy drive, and
press Enter. A list of mass storage devices is displayed.
6. Select the RAID disk array controller installed in your server from the list of
mass storage devices.
7. Follow the messages on the screen to continue to install.
Note
Installation Guide for more extensive installation procedures.
Note
LAN Adapter Drivers later in this chapter.
8. After installing Windows 2000, logon to the system using the administrator
account or other account, which is a member of the Administrator's group.
: Perform Steps 2 through 6 if a RAID controller is
: There is no visible indication on the screen when
: Please consult the Microsoft Windows 2000
: For LAN adapter driver installation, see Installing
Installing and Configuring Windows 2000 B-5
®
2000 Operating