Operation Instruction; Operation Guide; Error Message; Clock Mode - Reebok edge series User Manual

4. The DISTANCE will flash and you can press UP or DOWN keys to
5. The CAL will flash and you can press UP or DOWN keys to setting
6. Press START/STOP key to begin exercise.

Operation Instruction:

1. Plug in the power
Plug in the adaptor to the equipment or input the batteries in the back of bottom case
then the computer will produce a beep sound and then turn on the computer at the
Manual mode.
2. Program select and setting value
Ａ. Use the PROGRAM key to select program mode and then press ENTER to
confirm your exercise mode.
Ｂ. At the Manual mode, the computer will use the UP or DOWN key to set up your
workout TIME, DISTANCE and CALORIES. Press UP + DOWN keys can clear
out the setting value to zero.
C. Press the START/STOP key to begin exercise.
D. When you reach the target, the computer will produce beep sounds and then stop.
E. If you set up more than one target and you would like to reach next target, press
START/STOP key to keep on exercise.

Operation guide:

The computer will enter CLOCK setting mode when power on it. You should set up the
current time by the UP or DOWN keys to adjust the Hours and minutes.

Clock Mode:

a. The computer will enter the clock mode when there is no signal input or no keys be
pressed after 4 minutes. You can press ENTER key to switch the clock and
temperature at the clock mode or press other keys to quit the clock mode.
b. You can set up the CLOCK by holding ENTER key for over 2 seconds then adjust by
UP or DOWN keys.
c. By holding the ENTER and UP keys together for over two seconds, you can check the
current clock at "NO SPEED" mode.

Error Message:

E1 (ERROR 1): Normal state: During workout, when the monitor did not get the count
Power on state: The gear motor will return to zero automatically, when the
your exercise TIME. Press ENTER key to confirm your desired
workout TIME.
setting your target DISTANCE. Press ENTER key to confirm your
desired workout DISTANCE.
your exercise CALORIES. Press ENTER key to confirm your
desired workout CALORIES.
signal from the gear motor more than 4 seconds and check
under successive 3 times then the LCD will show E1.
signal of motor cannot be detected for more than 4