Pioneer DVR-645H-S Operating Instructions Manual page 142

DVR645H_WY_EN.book 142 ページ ２００６年７月５日 水曜日 午前１０時２５分
16
The Initial Setup menu
Setting
Angle Indicator
HDMI Output
(only available when an HDMI device is connected)
Screen Resolution
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case,
press ( PLAY ) while holding down the
switches Component Video Out on page 135 to the default setting).
4:3 Video Output
Colour
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
142
En
Options Explanation
On • A camera icon appears on-screen during multi-angle
scenes on a DVD-Video disc.
Off
Nothing is indicated on-screen when a multi-angle
scene is showing.
1920 x 1080i
Constant 1920 x 1080i output.
1280 x 720p Constant 1280 x 720p output.
720 x 576p
Constant 720 x 576p output (for use with the 625
input line system).
720 x 480p Constant 720 x 480p output (for use with the 525
input line system).
720 x 576i
Constant 720 x 576i output (for use with the 625 input
line system).
720 x 480i Constant 720 x 480i output (for use with the 525 input
line system).
( STOP ) button on the front panel to switch the setting (this also
Full
Select if your HDMI TV allows you to change the
aspect ratio.
Normal Select if your HDMI TV does not allow you to change
the aspect ratio. 4:3 video will be shown with bars on
each side (unless the Screen Resolution setting
(above) is set to 720 x 480i or 720 x 576i ).
RGB (0–255)
Use if colours are weak and black appears to 'float'
on the RGB (16–235) setting.
RGB (16–235) Use this setting if colours appear overly rich and the
black too deep on the RGB (0–255) setting.
YCbCr 4:2:2
The video signal is output as a 10-bit YCbCr 4:2:2
component signal. This is the standard setting for
HDMI-compatible devices.
YCbCr 4:4:4 The video signal is output as a 8-bit YCbCr 4:4:4
component signal.