Pioneer DVR-645H-S Operating Instructions Manual page 137

DVR645H_WY_EN.book 137 ページ ２００６年７月５日 水曜日 午前１０時２５分
The Initial Setup menu
Setting
Audio Out
Dolby Digital Out
DTS Out
96 kHz PCM Out
MPEG Out
Audio DRC
Audio DRC is not effective when listening via the digital output when the Dolby Digital Out setting is set to Dolby
Digital .
Options Explanation
Dolby Digital •
Output a Dolby Digital signal when a Dolby Digital
source is being played.
Dolby Digital Convert Dolby Digital sources to Linear PCM output.
PCM Use if your connected equipment doesn't have a
Dolby Digital decoder.
On •
Output a DTS signal when a DTS source is being
played.
Off Switch off the digital output when a DTS source is
being played. Use when your connected equipment
doesn't have a DTS decoder. In this case, use the
analog audio outputs.
96 kHz 48 kHz • Convert 96 kHz digital audio sources to 48 kHz
output. Use if your connected equipment doesn't
support 96 kHz sampling rate.
96 kHz Output 96 kHz digital audio when a 96 kHz source is
being played.
MPEG
Output an MPEG audio signal when a source using
MPEG audio is being played.
MPEG PCM • Convert sources with MPEG audio to Linear PCM
output. Use if your connected equipment doesn't
have an MPEG audio decoder.
On
Switches on Audio DRC (Dynamic Range Control).
Use when listening to Dolby Digital material at low
volume.
Off • Switches off Audio DRC.
16
137
En