Upgrading The System Memory - Gateway GT110 Series User Manual

34

Upgrading the system memory

This section explains the procedures for removing and installing a
memory module.
Memory configuration guideline
The GT110 has four DIMM slots. The DIMM slots support dual-channel
DDR2 unbuffered ECC memory modules.
• Channel A - DIMM A1 and DIMM A2
• Channel B - DIMM B1 and DIMM B2
For the system to function, DIMM modules must be installed following the
slot sequence listed below.
• To ensure data integrity, use only approved 240-pin, DDR2
unbufferred DIMM ECC modules in 1 GB or 2 GB capacities.
• Use identical modules — same specification for size, speed, and
organization.
• The minimum memory configuration is one DIMM, installed in DIMM
A1 slot.
• DIMMs on channel A (DIMM A1 and A2) are paired with DIMMs on
channel B (DIMM B1 and B2) to enable two-way interleaving. When
only two DIMMs are being used, the population order must be DIMM
A1 and DIMM B1 to ensure dual-channel operating mode.
• For best performance and dual-channel interleave operation, DIMM
modules must be installed or removed in matched pairs, following the
slot sequence: DIMM A1 and B1 first, then DIMM A2 and B2.
3 System upgrades