No Lights Are Lit On The Wireless Access Point; The Wireless Lan Activity Light Does Not Light Up; The Lan Light Is Not Lit - NETGEAR WNDAP350 Reference Manual

No lights are lit on the wireless access point

It takes a few seconds for the power indicator to light up. Wait a minute and check the power
light status on the access point.
If the access point has no power.
• Make sure the power cord is connected to the access point.
• Make sure the power adapter is connected to a functioning power outlet. If it is in a power
strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify
that it is not a switched outlet.
• Make sure you are using the correct NETGEAR power adapter supplied with your access
point.

The Wireless LAN activity light does not light up

The access point antennas are not working.
• If the Wireless LAN activity light stays off, disconnect the adapter from its power source
and then plug it in again.
• Make sure the antennas are tightly connected to the WNDAP350.
• Contact NETGEAR technical support if the Wireless LAN activity light remains off.

The LAN light is not lit

There is a hardware connection problem.Check these items:
• Make sure the cable connectors are securely plugged in at the access point and the
network device (hub, switch, or router). A switch, hub, or router must be installed between
the access point and the Ethernet LAN or broadband modem.
• LAN light does not light up if it is a 10 Mbps link. In such cases, the Lan activity light will
still blink if there is activity.
• Make sure the connected device is turned on.
• Be sure the correct cable is used. Use a standard Category 5 Ethernet patch cable. If the
network device has Auto Uplink™ (MDI/MDIX) ports, you can use either a crossover
cable or a normal patch cable.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Troubleshooting and Debugging
80