Setting Up And Testing Basic Wireless Connectivity - NETGEAR WNDAP350 Reference Manual

Figure 14. Basic QoS settings screen
2. Wi-Fi Multimedia (WMM) is enabled by default. Select the Disable radio button to disable
WMM support.
3. WMM Power Save is enabled by default. Select the Disable radio button to disable WMM
power save.
4. Click Apply to save your settings

Setting Up and Testing Basic Wireless Connectivity

Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your
needs.

To set up and test basic wireless connectivity:
1. From your Web browser, log in to the WNDAP350 using its default address of
http://192.168.1.1. Use the default user name of admin and default password of
password or use a new LAN address and password if you have set them up.
2. From the main menu under Configuration, select System. Verify that the correct
Country/Region in which the wireless interface will operate has been selected.
3. Click Apply to save any changes.
4. Under the Configuration tab, select Wireless from the main menu, and then select your
network, either the Wireless Settings 11b/bg/ng or Wireless Settings 11a/na. Ensure that the
auto channel (default) feature is selected for your network. This feature selects a channel
that has the least interference.
It should not be necessary to change the wireless channel unless you notice interference
problems or are near another wireless access point. Select a channel that is not being
used by any other wireless networks within several hundred feet of your wireless access
point.
ProSAFE Dual Band Wireless N Access Point WNDAP350
Basic Installation and Configuration
31