NETGEAR WNDAP350 Reference Manual page 19

ProSAFE Dual Band Wireless N Access Point WNDAP350
3. Click Login. The main menu of the WNDAP350 displays as shown in
Point Name and Country /
• When the wireless access point is connected to the Internet, under the Support tab,
select Documentation to view the documentation for the wireless access point.
• On the top-right of the screen, select Logout to exit the WNDAP350 setup screens.
(You will automatically be logged out of the wireless access point after 5 minutes of
no activity.)
Figure 5. Access Point Name and Country / Region
4. Access Point Name. Enter the access point name of the WNDAP350.
This unique name is the access point NetBIOS name. The default Access Point Name is
located on the bottom label of WNDAP350. The default is netgearxxxxxx, where xxxxxx
represents the last 6 digits of the WNDAP350 MAC address. You may modify the default
name with a unique name up to 15 characters long.
5. From the Country/Region pull-down menu, select the region where the WNDAP350 can be
used (the default Country/Region is the United States).
Note: If your country or region is not listed, please check with NETGEAR
Support.
6. Spanning Tree Protocol. Enable or disable spanning tree protocol. Spanning tree protocol
enables network traffic optimization in settings with multiple WNDAP350 wireless access
points. The default is Disable.
7. 802.1Q VLAN. This section allows each Security Profile to be associated with the default
VLAN for WNDAP350. (Useful primarily if the hubs/switches on your LAN support the VLAN
802.1Q standard.)
- Untagged VLAN. Untagged VLANs do not cause the outbound traffic to be tagged
with the VLAN ID. Also, there can be only one Untagged VLAN. The default is Enable
and set to 1.
- Management VLAN. Management VLANs are used for managing traffic (Telnet,
SNMP, and HTTP) to and from the Access Point. Management VLANs also cause
Region.
Basic Installation and Configuration
19
Figure 5, Access