Wireless Settings; Configuring 802.11B/Bg/Ng Wireless Settings - NETGEAR WNDAP350 Reference Manual

Prosafe dual band wireless n access point

Hide thumbs Also See for WNDAP350:

Reference manual (138 pages)

User manual (136 pages)

Product data (2 pages)

Table Of Contents

100

101

102

103

104

Table of Contents

Enter the IP Address fields of the WNDAP350.

•

DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is

disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless

access point will get its IP address, subnet mask and default gateway settings

automatically from the DHCP server on your network when you connect the

WNDAP350 to your LAN.

•

IP Address. Enter the IP Address of your wireless access point. The default IP

address is 192.168.1.1. To change it, enter an unused IP address from the address

range used on your LAN; or enable DHCP.

•

IP Subnet Mask. The Access Point will automatically calculate the subnet mask

based on the IP address that you assign. Otherwise, you can use 255.255.255.0 (the

default) as the subnet mask.

•

Default Gateway. Enter the IP address of the gateway for your LAN. For more

complex networks, enter the address of the router for the network segment to which

the wireless access point is connected.

•

Primary DNS Servers. The WNDAP350 will use this IP address as the primary

Domain Name Server used by stations on your LAN.

•

Secondary DNS Servers. The WNDAP350 will use this IP address as the secondary

Domain Name Server used by stations on your LAN.

•

Network Integrity Check. Check this box to enable the WNDAP350 to validate that

the upstream link is active before allowing wirelessassociations.If you set this option

you must ensure your default gateway is configured.

Click Apply to save your basic IP settings.