MASSEY FERGUSON 410 Operators Instruction Book page 55

Drawbar length
To adjust the drawbar for length (Fig. 72) proceed
as follows:
1. Remove the bolt and keep plate (1).
2. Pull the pin retaining spring (2) to the left side
release the pin. Remove the drawbar pin (3).
3. Reposition the drawbar (4) using one of the three
holes (5) (See Table 2).
4. Refit the pin (3), keep plate and bolt (1).
Drawbar height
To adjust the drawbar height ( Fig. 73) proceed as
follows:
1. Remove the drawbar pivot pin as described in
'Drawbar length'.
2. Remove the clevis and reposition in one of the
positions shown, (Fig. 73), the dimensions from the
center of the PTO shaft are given in Table 2. Tighten
the bolts to a torque of 230 Nm (170 lb.ft).
3. Refit the drawbar
Position
A
B
C
D
Table 3
Drawbar lateral adjustment
The drawbar (Fig. 75) may be fixed in any one of five
positions or allowed to swing the full width of the
frame.
The maximum lateral swing is 240mm (9.5 in).
To change the position of the drawbar ( Fig. 74)
1. Remove the four 'R' clips (1).
2. Remove the two limit pins (2).
3. Reposition the drawbar (3), and refit the pins and
'R''clips (Fig. 74), or leave it free to swing. Store the
pins and 'R' clips in the tool box when not in use.
Drawbar off-set when in the center hole (Fig. 75).
Position
A
Table 4
Allow the drawbar to swing when pulling ground
engaging equipment which does not require accurate
positioning. This will make steering and turning easier.
Fix the position of the drawbar when pulling or
transporting equipment which requires accurate
positioning.
NOTE: The lock-nuts securing the drawbar frame to
the underside of the tractor must be kept tightened
to a torque of 420 Nm (310 lbf ft). The lock-nuts
securing the drawbar frame must be kept tightened
to a torque of 245 Nm (180 lbf ft).
410/420/430 - 001 8903 U1
UZEL
Height
165 mm (6.5 in)
270 mm (10.5 in)
67 mm (2.6 in)
172 mm (6.8 in)
Drawbar off-set
198 mm (7.8 in)
Fig. 74
Fig. 75
Operation
55