Liquid Crystal Display Module - Toshiba T3300SL Maintenance Manual

4.11 Liquid Crystal Display Module

4.11.1 Removing the Display Mask, FL Inverter Board, LCD Module, and Back Cover
1. Turn off the power to the T3300SL. Disconnect the AC adapter and all external cables
connected to the T3300SL.
2. Remove the battery pack as instructed in Section 4.2.
3. Place the T3300SL in front of you as if you were going to use it and the open the display.
4. Remove the two rubber cushions on the top of the display module, and the two rubber
seals from the bottom of the display module to expose the screws securing the display
mask. Remove the two M2.5x6 screws securing the bottom of the display mask and the
two M2x6 screws securing the top of the display mask (Figure 4-33).
Figure 4-33 Removing the rubber cushions, seals, and display mask screws
4-35