TP-Link Archer C20 User Manual page 30

Band - This field displayed the operating frequency being configured.

Mode - This field determines the wireless mode which the router works on.

11bg mixed - Select if you are using both 802.11b and 802.11g wireless clients.

11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless

clients.
Channel Width - Select any channel width from the drop-down list. The default setting

is "Auto", which can adjust the channel width for your clients automatically.
Channel - This field determines which operating frequency will be used. It is not

necessary to change the wireless channel unless you notice interference problems with
another nearby access point. If you select "Auto", then the AP will select the best
channel automatically.
7. Configure the basic parameters for 5GHz wireless network in the following screen as shown
in Figure 3-14, and then click Next.
Wireless Network Name - Also called the SSID (Service Set Identification). Enter a

value of up to 32 characters. The same name must be assigned to all wireless devices
in your network. The default SSID is set to be TP-LINK_XXXX_5G. This value is
case-sensitive. For example, TEST is NOT the same as test.
Archer C20
Figure 3-14 Quick Setup – Wireless 5GHz
- 18 -
AC750 Wireless Dual Band Router