Surround Panels Installation (Required Accessory) - Superior DRI3030TEN Installation And Operation Manual

Direct-vent fireplace insert
Hide thumbs Also See for DRI3030TEN:
Table of Contents

Advertisement

Figure 10
4. Install a light layer of glowing embers (rockwool) directly over the ports.
- A light layer will give a more constant rear flame.
- A heavy layer will give more glow, but will need to
be adjusted after light up.
Figure 11
5. Install front logs on retainer slots.
Figure 12
6. Place volcanic stones around the perimeter of the glowing embers
(rockwool).
IMPORTANT!!! Do not cover the ports with volcanic stone.
7. Place top log on pin.
18
Side Firebox Panels
Front Logs
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Top Log
Figure 13
Surround Installation
The fireplace insert surround panels are made of heavy gage steel for
durability and, if desired, for the ease of making an inside fit in the fire-
place. See Packaging List for available sizes.
1. Remove the speed nuts (A in Figure 14) from the parts bag and install
(with the flat surface forward) on the six holes in the surround brack-
ets - three on each side of the insert (B in Figure 14). A flat bladed
screwdriver may help in installing the nuts.
2. Install all surround panels and trim with the appliance positioned in
the fireplace, but a few inches in front of its final location.
3. If an Arch face is to be installed on the appliance, the sight obstructor
that comes with the face must be installed prior to installing the sur-
round panels. See the instructions included with the face for proper
sight obstructor installation.
4. Install the side surround panels by lining up the holes in the tabs on
the side surround panels in front of the holes on the surround brackets.
Next insert two slotted 1/4" truss screws for each side surround panel
and secure loosely.
5. Fasten the top surround panel with the remaining two truss screws.
Tighten all six truss screws after adjusting the surround panels to
eliminate space between side and top surround panels.
6. Assemble the surround trim by inserting the elbowed retainer in the
rectangular slot in the ends of the longest piece of trim and secure by
tightening the screw in the retainer. Slide the mitred ends of the two
side trim pieces onto the elbowed retainer and secure by tightening
the retainer screw.
7. The fastened trim pieces should now be horseshoe shaped. Slide the
trim down over the surround panels so the edge of the surround panel
fits just behind the rounded edge of the trim.
8. Install three spring clips (found in parts bag in firebox) in each piece
of trim by inserting them between the rear of the surround and the
channel of the trim. The spring clips will push the trim tight to the
surround.
B
A = Speed nuts
B = Holes in the surround brackets - three on each side
Figure 14
C = Location where hooked brackets on face will hang
Ports
A
C
Latches
B

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dri2530ten

Table of Contents