Table of Contents
Advertisement
Adjusting Levels for Analog Sources
2
3
Note:
4
Note:
the picture will change while it is working and then will change back to normal.
5
6
7
8
34
To access the
INPUT LEVELS
I np u t L ev els
From the computer source, display an all-black picture. This must come from the
computer source that will be used for the program. We suggest you display a screen
using the Windows Paint program. (See "Making a Checkerboard Pattern With
Paint" on page 39)
Black Level must be done before White Level.
In the
menu, select
INPUT LEVELS
line says "Working..." until the process is complete.
When doing Auto Black and Auto White with an interlaced analog input, the color of
From the computer source, display an all-white picture.
In the
menu, select
INPUT LEVELS
"Working..." to disappear.
The display is now adjusted to the black and white levels of this computer using
this video card. If you change computers or video output cards in the computer,
you must do this again.
Although it is not required, we recommend that you save the configuration to a
memory slot. (See "Saving Configurations" on page 86)
If you have more than one source coming through the same connector, adjust
Input Levels for each source.
m52L Installation Guide
menu, press
LEVEL
A ut o B la ck L eve l (o f f set )
A ut o W h it e L ev el ( ga in )
C en t er P oi n t
B l ac k L ev el ( o f fs et ) -A l l
R ed
G r e e n
B lu e
Wh ite L eve l (g a in )-A ll
R ed
G r e e n
B lu e
AUTO BLACK LEVEL
AUTO WHITE LEVEL
on the remote.
64
12 4
99
79
89
67
83
99
99
99
99
and press
ENTER
and press
ENTER
. This menu
. Wait for
Advertisement
Table of Contents
