Installing An M52L; Before You Begin; Plan Your Installation; Prepare Your Installation Location - Planar m52L Installation Manual

Installing an m52L

This section explains how to install an m52L. We suggest that you read the entire
section before you attempt to install the unit.

Before You Begin

Make sure you have all the items in these checklists before you begin unpacking and
installing your m52L(s).

Plan Your Installation

You should have a detailed plan of how the units are to be configured. The plan
should include calculations for the following:

Prepare Your Installation Location

You should have prepared the area where you will install the unit. If custom
enclosures are part of the installation, they must be fully designed to accommodate
the installed unit and ventilation and cooling requirements.

Tools and Other Things You May Need

• Power (maximum of three units per 20A circuit for 115V operation)
• Cable runs
• Ventilation and cooling requirements
• If hanging display on a wall, location of studs in the wall
• Tools:
• Needle nose pliers to remove staples from the bottom of the shipping box
• Utility knife to cut shrink wrap or box banding
• Level to ensure the display is hung straight
• Stud finder (if hanging display on a wall)
• Computer network LAN cables (straight through - no crossover) to interconnect
multiple displays for RS232 control
• LCD screen cleaner or LCD wipes - available at most electronics stores
• At least two very strong people to help lift units into place
m52L Installation Guide 9