Desa CGEFP33PR Owner's Operation And Installation Manual page 25

INSTALLATION
Continued
3. Locate the notches in the bottom of the front
log (#3). Place the front log on the grate fin-
gers. Make sure the notches of the front log
line up with the grate fingers (see Figure 47).
4. Place crossover log (#4) onto the peg (right)
on back log (#2) and into the recess of the
middle log (#1) (see Figure 48).
Notches
Grate
Fingers
Figure 47 - Installing Front Log (#3)
Crossover
Log (#4)
Figure 48 - Installing Crossover Log (#4)
108117-01K
INSTALLING BATTERY INTO
REMOTE
1. Locate slot at bottom of remote control (see
Figure 49). Firmly insert tool such as a small
screwdriver, butter knife, or dime into the slot
and lift up to remove cover.
2. Insert supplied battery into remote control.
Positive and negative are marked inside re-
mote control casing. Note: Remote will not
function if battery is not installed correctly.
Front Log
3. Slide tab on cover into remote housing and
(#3)
snap cover back into place.
IMPORTANT: Use only A23 12 volt battery in
remote. DO NOT use AAA battery.
A23 12
Volt
Battery
Positive
Peg
INSTALLING SCREEN
Install fireplace screen by slipping notches of fire-
place screen over screws on front of fireplace (see
Figure 50).
Recess
Figure 50 - Installing Fireplace Screen
www.desatech.com
Slot
Negative
Figure 49 - Installing Battery
Notches
Screws for
Mounting Screen
(EFP33PR Shown)
Tab
Cover
Remote
Control
25