Desa CGEFP33PR Owner's Operation And Installation Manual page 23

INSTALLATION
Continued
INSTALLING HOOD
Install hood to top of firebox as shown in Figure
40. Use 3 Phillips screws provided.
Figure 40 - Installing Hood to Firebox
(EFP33PR Shown)
INSTALLING LOGS (CGEFP33PR/
CGEFP33NR)
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
CAUTION: After installation
and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log.
If so, reposition logs according
to the log installation instruc-
tions in this manual. Flames con-
tacting logs will create soot.
Each log is marked with a number. These num-
bers will help you identify the log when install-
ing. It is very important to install these logs ex-
108117-01K
actly as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Locate pegs on the bottom of back log (#1).
Slide these pegs into the holes in the grate base
behind the burner (see Figure 41).
2. Place the base of the middle log (#2) in the U-
shaped slots of the grate base in front of the
back log. The cutout on the right of the middle
log should fit over the burner (see Figure 42).
Make sure the front of the middle log is rest-
ing on the tabs of the grate base and the cut-
out area is centered over the burner "U" bend.
3. Locate the recesses on the back of the front
log (#3). Fit these recesses between the posts
of the grate base (see Figure 43, page 24).
4. Locate the notches in the bottom of the cross-
over log (#4). Place the crossover log on top
of the middle log and front log. Make sure the
notches of the crossover log lines up with rect-
angular knobs on top of the middle and front
logs (see Figure 44, page 24).
Hole in
Grate Base
Figure 41 - Installing Back Log (#1)
Middle
Log (#2)
Burner
U-Shaped Slot
Figure 42 - Installing Middle Log (#2)
www.desatech.com
Tab
Back
Log (#1)
Burner
Cutout
"U" Bend
23