Desa CGEFP33PR Owner's Operation And Installation Manual page 24

INSTALLATION
Continued
Post
Figure 43 - Installing Front Log (#3)
Rectangular
Knobs
Figure 44 - Installing Crossover Log (#4)
INSTALLING LOGS (EFP33PR/
EFP33NR)
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
24
Front Log (#3)
Recess
Post
Crossover
Log (#4)
www.desatech.com
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to HIGH, check to see
if flames contact any log. If so,
reposition logs according to the
log installation instructions in
this manual. Flames contacting
logs will create soot.
Each log is marked with a number. These num-
bers will help you identify the log when install-
ing. It is very important to install these logs ex-
actly as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place the base of the middle log (#1) in the U-
shaped slots of the grate base. The cutout on the
right of the middle log should fit over the burner
(see Figure 45). Make sure the front of the middle
log is resting on the tabs of the grate base and the
cutout area is centered over the burner "U" bend.
2. Locate pegs on the bottom of back log (#2).
Slide these pegs into the holes in the grate base
behind the burner (see Figure 46).
"U"-
shaped
Cutout in
Base
Figure 45 - Installing Middle Log (#1)
Peg
Figure 46 - Installing Back Log (#2)
Middle
Log (#1)
Burner
Back Log
(#2)
Peg
108117-01K