Desa CGEFP33PR Owner's Operation And Installation Manual page 13

INSTALLATION
Continued
8. Plug in blower power cord.
a. If your fireplace system is installed as a free-
standing unit with an accessory mantel, de-
termine whether the power cord will exit the
left side or the right side of the firebox. In-
stall 1 plastic bushing provided into the 1.5"
hole in the floor support bracket on the exit
side (see Figure 16). Install the second plas-
tic bushing provided into the 1.5" hole in the
outer casing through which the power cord
will exit. Route power cord through both
plastic bushings and plug the power cord into
a properly grounded 3-prong wall receptacle
near the firebox.
b. If your fireplace system installation is re-
cessed and if an outlet is not installed in
your fireplace, you must install the GA3555
Outlet kit with cover in your fireplace which
will supply a convenient 3-prong grounded
electrical outlet for your blower. Refer to the
installation manual provided with the model
GA3555 accessory for instructions on wir-
ing the duplex outlet.
Note: A qualified installer must make all
electrical connections.
9. Check to make sure that all electrical cords
are completely clear of the blower wheel and
that there are no other foreign objects in
blower wheel. Turn blower on and check for
operation. Turn blower off by rotating knob
fully counterclockwise before continuing.
CAUTION: Never touch the
blower wheel while in operation.
10. Peel off backing paper and stick supplied wir-
ing diagram decal near center of firebox bot-
tom (Figure 17).
11. If gas connections have been made and
checked, replace fireplace floor assembly.
Feed flexible gas supply line into fireplace
base area while replacing fireplace floor as-
sembly. Make sure the entire flexible gas line
is in fireplace base area.
IMPORTANT: Do not pick up fireplace floor
assembly by burners. This could damage burn-
ers. Only handle base by grates. Note: Be
careful of all wires and components on un-
derside of floor assembly.
108117-01K
Right Floor
Support Bracket
Figure 16 - Installing Plastic Bushing for
Wiring
Diagram
WARNING: Never attempt to service
heater while it is plugged in, operating, or
hot. Burns and electrical shock could result.
Only a qualified service person should ser-
vice or repair heater.
If any of the original wire as supplied with the appli-
ance must be replaced, it must be replaced with
105°C wire or it's equivalent.
WARNING: Label all wires prior to discon-
nection when servicing controls. Wiring errors
can cause improper and dangerous operation.
Verify proper operation after servicing.
120 Vac. 60 Hz. . 78 Amps
DESA Heating Products, Bowling Green, KY
Figure 17 - Location of Wiring Diagram
www.desatech.com
Power Cord
Variable
Fan Switch
Off
On
110/115
V.A.C.
Black
Green
White
Decal 3" from Blower
Plastic
Bushing
Blower
Motor
Black
White
101584-05
13