Desa CGEFP33PR Owner's Operation And Installation Manual page 22

INSTALLATION
Continued
Mantel Clearances for Built-In
Installation
If placing mantel above built-in fireplace, you must
meet minimum clearance between mantel shelf
and top of fireplace opening.
NOTICE: Surface temperatures
of adjacent walls and mantels
become hot during operation.
Walls and mantels above the fire-
box may become hot to the touch.
If installed properly, these tem-
peratures meet the requirement
of the national product standard.
Follow all minimum clearances
shown in this manual.
NOTICE: If your installation does
not meet the minimum clear-
ances shown, you must do one
of the following:
• raise the mantel shelf to an
acceptable height
• remove the mantel shelf
Wall board or facing
material (above
firebox) may be of
combustible material,
including decorative
mantel ornaments or
other similar projec-
tions off of the facing
material.
Framing
Material
Firebox
Wire-mesh
Screen
Figure 37 - Minimum Mantel Clearances
for Built-In Installation
22
Mantel Shelf
10"
8"
6"
1 /2
2 "
Noncombustible
Material May
Project Off this
Surface above
the Firebox
13" 16" 19" 21"
Hood
Note: All vertical
measurements are
Supplied
from top of fireplace
Firebox
hood opening to
Hood
bottom of mantel
Must Be
shelf. These minimum
Used at
clearances replace any
All Times
other recommended
clearances supplied
with your ANSI Z21.11.2
approved gas logs.
www.desatech.com
ASSEMBLING AND ATTACHING
OPTIONAL BRASS TRIM
(Included with Mantel Accessory)
Note: The instructions below show assembling and
attaching brass trim to fireplace.
1. Remove packaging from three pieces of brass trim.
2. Locate four brass screws, two adjusting plates
with set screws, and two shims in the hard-
ware packet.
3. Align shim under adjusting plate as shown in
Figure 38.
4. Slide one end of adjusting plate/shim in slot on
mitered edge of top brass trim (see Figure 38).
5. Slide other end of adjusting plate/shim in slot on
mitered edge of side brass trim (see Figure 38).
6. While firmly holding edges of brass trim to-
gether, tighten both set screws on the adjust-
ing plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place the as-
sembled trim onto fireplace cabinet. Align
hanging notches on trim with hanging screws
on side of fireplace (see Figure 39). Push trim
firmly into place, sliding hanging notches over
hanging screws.
Side
Adjusting
Brass
Plate
Trim
Mitered Edge
Slot
Figure 38 - Assembling Brass Trim
Assembled
Brass Trim
Figure 39 - Attaching Brass Trim to
Fireplace (EFP33PR Shown)
Set Screws
Top
Brass
Trim
Shim
Slot
Trim Hanging
Screws
Hanging
Notches
on Trim
108117-01K