Desa CGEFP33PR Owner's Operation And Installation Manual page 12

INSTALLATION
Continued
Mounting Wall Switch to Side of Mantel
7. Create three openings in the mantel wall ac-
cording to Template 2, page 39. This is best
done by making a pattern to work with on the
mantel. Carefully cut page 41/42 from manual
and tape paper template vertically onto man-
tel wall at preferred location. Pierce the paper
at the centers of the 2 holes with a nail or sharp
pencil, leaving a mark on the wall. Do the
same at centers of the four circles near the cor-
ners of the rectangle.
8. Remove paper template from mantel wall.
9. Drill 1/8" pilot holes at each mark for top and
bottom screw holes. Drill 3/8" holes at each
mark for centers of four circles near corners
of rectangle.
10. Using a straight edge and pencil, connect the
outer edges of the 4 holes for the rectangle
(see Figure 10, page 11). This will give you
cutting lines for the rectangle you will cut in
the mantel wall.
11. Using a keyhole saw, hack saw blade, drill, file,
or other suitable tool, carefully cut out the rect-
angular opening. Note: The corners of the rect-
angle may be round. IMPORTANT: Do not ex-
ceed the size of the rectangle on template.
12. Carefully pass switch/plate assembly through
rectangular opening from inside mantel (see
Figure 13, page 11).
13. Position switch/plate assembly vertically over
opening with decal lettering upright. Make
sure wires freely pass through wall without
binding. Align holes in wall plate with 1/8"
pilot holes in mantel wall.
14. Drive mounting screws, removed in step 2 of
Relocating Wall Switch on page 10, through wall
plate holes and into pilot holes in mantel wall.
15. Tighten screws until wall plate is firmly at-
tached to mantel. Do not overtighten.
INSTALLING VARIABLE SPEED
BLOWER ACCESSORY
NOTICE: Shut off gas supply
and disconnect heater from gas
supply if installing blower into
previously installed fireplace.
Contact a qualified service per-
son to do this.
12
1. If fireplace screen and floor are still installed,
see Removing Fireplace Screen and Floor
Assembly, page 9.
2. Attach the power cord to the blower motor by
firmly pushing the two female terminals at the
end of the power cord onto the two spade ter-
minals on the blower motor.
3. Attach green ground wire from power cord to
blower housing using screw provided (see Fig-
ure 14). Tighten screws securely.
4. Place the blower against lower rear wall of
firebox outer wrapper with the exhaust port
directed upward. Align the holes in top mount-
ing tabs of blower with holes in wall of wrap-
per (see Figure 14). Using 2 screws provided,
mount blower and tighten screws securely.
5. Be certain that all wire terminals are securely
attached to terminals on blower motor and that
the screw retaining the green ground wire is tight.
6. Place control knob provided on plastic con-
trol shaft of speed control.
7. Mount the speed control on the front leg of
the left floor support bracket using 2 screws
provided (see Figure 15).
Blower
Screws
Green Ground Wire
Figure 14 - Mounting Blower to Firebox
Left Floor
Support
Bracket
Speed
Control
Screws
Control
Knob
Figure 15 - Attaching Speed Control to
www.desatech.com
Exhaust
Port
Screw
Top
Mounting
Tab
Control
Shaft
Firebox
Lower Rear
Wall of
Firebox
108117-01K