Mercedes-Benz 2008 CL 550 4MATIC Operator's Manual page 144

Control systems
COMAND navigation system (during route guidance)
i COMAND uses the time set in COMAND
as the basis for calculating the estimated
arrival time. The clock must be set correctly
Y
in COMAND ( page 92). The calculation of
the estimated arrival time does not
additionally take into account whether
Daylight Saving Time or standard time is
applicable at the destination. If the
destination is in a different time zone,
arrival time display
9
is indicated by LT in the display.
The following data cannot be seen until the
route calculation has been completed:
Distance to destination
R
Estimated arrival time
R
Estimated remaining travel time
R
If the destination is located within a
partially digitized area, the following data
may differ from the facts:
Distance to destination
R
Estimated arrival time
R
Estimated remaining travel time
R
142
More user manuals on
Displaying route information
X Select Route
with the menu system displayed
( Y page 103).
The route information appears.
is in local time. This
2
9
8
Highlighted portion of route
1
Info for highlighted portion of route
2
Next portion of route
3
X
Closing route info: Slide
2
back button
9
( Y page 86).
8
X
Displaying next or previous route
section: Select Next or Previous.
ManualsBase.com
Route Info in map view
£
or press
omp
in the center console
L
X
Increasing or reducing size of the map:
Select or :.
;
X Closing route browser: Select Back.
Detour function
i The detour function blocks a section of
the route ahead of you. You can set the
length of the blockage. If possible,
COMAND calculates a detour route.
i
The detour function may direct you to off-
road routes. See Off-road and Off-map for
additional routes and cautions
( Y page 138).
X Select Route Detour in map view with
£
the menu system displayed (
The detour function display appears.
X
Setting length of the blockage: Select
More or Less until the desired length is set.
Y page 103).