Wiring Harness Connections; General Controls - JL Audio MediaMaster 100s Owner's Manual

WIRING HARNESS CONNECTIONS

Harnesses exiting the rear of the unit are used to connect to aftermarket amplifiers/
equipment and media devices. Depending on your specific equipment, you may or
may not use all of the connections. Make sure to plan the layout of your system
prior to routing wires and making connections. Refer to the table below for
additional info.
Label Description
Black RCA
ZONE1
(MAIN)
Red RCA
Black RCA
ZONE2
Red RCA
Black RCA
ZONE3
(SUB)
Red RCA
ZONE4 Black RCA
(FIXED
Red RCA
LEVEL)
Black RCA
AUX-IN
Red RCA
SiriusXM 10-pin Connector
ANT Antenna
USB USB Connector
5-pin Threaded
REMOTE
Connector
4-pin Deutsch
CAN
Connector

GENERAL CONTROLS

Left Channel Signal Output / Zone 1 (Main)
Right Channel Signal Output / Zone 1 (Main)
Left Channel Signal Output / Zone 2
Right Channel Signal Output / Zone 2
Left Channel Signal Output / Zone 3 (Subwoofer)
Right Channel Signal Output / Zone 3 (Subwoofer)
Left Channel Signal Output / Zone 4 (Fixed level)
Right Channel Signal Output / Zone 4 (Fixed level)
Left Channel Signal Input / Auxiliary
Right Channel Signal Input / Auxiliary
Connect to SiriusXM® tuner (sold separately)
Connect to Motorola style antenna
Connect to USB storage device or iPhone®
Connect to MMR-20 remote (sold separately)
Connect to NMEA network (requires NMEA 2000
compatible cables, connectors, etc. (sold separately)
7
Connection
4V RMS MAX
Output Voltage
4V, 2V, or 1V RMS
MAX Output
Voltage
2V or 1V RMS
Input
Sensitivity