Mounting And Installation - JL Audio MediaMaster 100s Owner's Manual

MOUNTING AND INSTALLATION

The diagram below shows a typical
mounting procedure into a fiberglass
panel. Always follow proper safety
procedures. Wear eye-protection
at all times with a dust mask and
gloves when cutting. A mounting
template is included to aid in
measuring and marking the mounting
1.
surface before cutting or drilling.
Press along the perforation to
remove the center section of the
mounting template. (Discard the
center section.) The template can
be used to verify there is sufficient
flat surface area for mounting
and as a guide for cutting the
opening. Tape the template
to the mounting location and
mark the surface for cutting the
opening and drilling pilot holes.
Before drilling or cutting, make sure
there is adequate space behind the
mounting surface to fit the MM100s,
including its wire harness.
2.
Use a jigsaw or rotary tool to cut an
opening in the mounting surface.
If necessary, use a file or sandpaper
to adjust the opening for proper
3.
fitment and smooth the edges.
Place the MM100s into the opening
and check that the mounting
holes remain aligned with the
pilot hole marks taken from
the template. If not, adjust and
4.
mark new holes as necessary.
Remove the MM100s and drill four
(4) pilot holes in the mounting
5.
surface at the pilot hole marks.
Peel the adhesive backing
from the mounting gasket and
affix to the rear of the bezel.
Connect all wiring and place
6.
the MM100s into the opening.
Secure the MM100s using the
four (4) stainless steel screws.
Press the trim ring onto the
front of the MM100s.
5