Table of Contents
Advertisement
5A Fuse
POWER CONNECTIONS
The 4-pin plug with wire leads is used
to make power related connections.
Make sure to carefully plan the wiring of
your system prior to routing wires and
making connections. Refer to the table
below when making power connections.
Label
Wire Color
+12VDC
GROUND
ILLUMINATION
AMP TURN-ON
ANT – Motorola® Style Antenna
AUX-IN – To PreAmp Aux Source
ZONE1 (MAIN)
ZONE2
ZONE3 (SUB)
ZONE4 (FIXED LEVEL)
USB – USB Storage Media or iPhone® 5 or 6
REMOTE – MediaMaster® MMR-20 Remote Control (Sold Separately)
CAN – NMEA2K Network
SIRIUSXM – SiriusXM® Connect Tuner (Sold Separately)
Connect to a positive (+12V) source. This can be an ignition controlled,
accessory circuit or a vessel battery equipped with a main disconnect
switch. For added control functionality, we also recommend installing
Red
a dedicated toggle switch (not included) at this wire lead's +12V
connection point. Always install an appropriate fuse within 18 inches
(45 cm) of the +12V connection. If this is the only device using the
connection point, use a 5 amp fuse.
Connect to a clean metal chassis ground, if available. If no metal chassis
ground is available, it may be necessary to connect this to the NEGATIVE
Black
battery post. All ground connections (source unit and amplifiers)
should be made at the same location to minimize noise.
Connect to a +12V lighting circuit to automatically switch the
Orange
illumination to night mode when the lights are activated.
This wire provides a positive (+12V) turn-on voltage to activate
Blue
aftermarket amplifiers.
GENERAL CONNECTIONS
To Ampli er
POWER CONNECTIONS
–
+12VDC (Red)
ILLUMINATION (Orange)
GROUND (Black)
AMP TURN-ON (Blue)
Disconnect the NEGATIVE battery
post connection and secure the
disconnected cable to prevent
accidental reconnection. This is
an essential safety precaution
during installation!
Connection
6
Switched +12V Power
–
+12V Lighting Circuit
–
Ground
–
Remote Output to Ampli er
Hide quick links:
Advertisement
Table of Contents
