Icom IC-FR3000 Service Manual page 73

SECTION 1
' ' GENERAL
• Frequency range
• Type of emission
• Frequency resolution
• Number of channels
• Antenna connector
• Power supply requirement
• Current drain (at 13.6 V)
• Operating temperature range
• Dimensions (projections not included)
• Weight
' ' TRANSMITTER
• Output power
• Modulation system
• Max. frequency deviation
• Spurious emissions
• Adjacent channel power
• Input impedance
' ' RECEIVER
• Receiving system
• Intermediate frequency
• Sensitivity (12 dB SINAD)
• Adjacent channel selectivity
• Spurious response
• Intermodulation
• Audio output power
• Audio output impedance
All stated specifications are subject to change without notice or obligation.
SPECIFICATIONS
: 450–480 MHz
: 16K0F3E / 8K50F3E
: 25 or 12.5 kHz
: Max. 32 channel
:N-type × 2 (50 Ω)
: 100–120 V AC
: Less than 20 A (TX)
: –30˚C to +60˚C (–22˚F to +140˚F)
: 410 (W) × 110 (H) × 360 (D) mm
: 12 kg (26.5 lb)
: 50 W
: Variable reactance frequency modulation
: ±5.0 kHz (Wide) / ±2.5 kHz (Narrow)
: –70 dBc typical
: More than 70 dB (Wide)
: 600 Ω
: Double conversion superheterodyne system
: 1st; 70 MHz
: 0.5 µV; 12 dB SINAD
: More than 70 dB (Wide)
: More than 70 dB
: More than 70 dB
: 2.5 W at 10% distortion with an 4 Ω load
: 4 Ω
[120V VERSION]
220–240 V AC [220V VERSION]
13.6 V (negative ground)
Less than 1A (RX standby)
Less than 2A (RX max power)
16.1 (W) × 4.3 (H) × 14.1 (D) inch
More than 60 dB (Narrow)
2nd; 455 kHz
More than 60 dB (Narrow)
1 - 1