Icom IC-FR3000 Service Manual page 4

SECTION 1 SPECIFICATIONS
Measurement method
Frequency range
Type of emission
Channel spacing
Frequency stability
Number of channels
Antenna connector
Power supply requirement
Current drain (approx.)
Operating temperature range
Dimensions (proj. not included)
Weight
RF output power (High/Low)
Modulation system
Maximum frequency deviation
Spurious emissions
Adjacent channel power
Input impedance
Receive system
Intermediate frequencies
Sensitivity (typical)
Adjacent channel selectivity (typical)
Spurious response
Intermodulation (typical)
Audio output power
Audio output impedance
All stated specifications are subject to change without notice or obligation.
[USA2], [GEN2], [GEN4]
EIA / TIA-603
W/N (25 kHz; Wide / 12.5 kHz; Narrow): 16K0F3E / 8K50F3E
M/N (20 kHz; Middle / 12.5 kHz; Narrow): 14K0F3E / 8K50F3E
25 or 12.5 kHz (Wide / Narrow)
20 or 12.5 kHz (Middle / Narrow)
±2.5 ppm
100 V–120 V [USA2], [GEN2]
220 V–240 V [GEN4], [EUR2], [FRG2]
13.6 V DC (negative ground)
TX (at 50 W) 15.0 A
–30˚C to +60˚C (–22˚F to +140˚F)
410(W) × 110(H) × 360(D) mm; 16.1 (W)
50 W / 10 W
Variable reactance frequency modulation
±5.0 kHz [Wide], ±4.0 kHz [Middle], ±2.5 kHz [Narrow]
70 dBc typical
70 dB [Wide]/[middle], 60 dB [Narrow]
Double-conversion superheterodyne system
1st: 31.65 MHz, 2nd: 455 kHz
0.5 µV at 12 dB SINAD
70 dB [Wide]/[Middle], 60 dB [Narrow]
2.5 W typical at 10% distortion with a 4 Ω load
1 - 1
[EUR2], [FRG2]
ETS 300 086
150.000–174.000 MHz
[USA2], [GEN2], [GEN4], [EUR2]
Max. 32 channel
2 (50 Ω)
×
N-type
13.2 V DC (negative ground)
TX (at 25 W) 10.0 A
RX (max. audio) 2 A
(stand-by) 1 A
–25˚C to +55˚C
× ×
4.3 (H) 14.1 (D) inch
12 kg; 26.5 lb
0.25 µW ≤ 1GHz, 1.0 µW > 1 GHz
600 Ω
6 dBµV (emf) at 20 dB SINAD
70 dB
70 dB
4 Ω
[FRG2]
±1.0 kHz
25 W / 5 W