Ice Maker (Shown Here With Cover Off) - Viking RDDFF236 Service Manual

Service Diagnostics and procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Freezer Drawer, Bins, Baskets, glides
and glide adapters (continued)
12. Remove securing screws to remove left and
right lower basket glide adapters.
Screw
13. Replace or repair as necessary.
14. Reverse procedure to reinstall.
© 2012 Viking Preferred Service
WARNING
Screw

Ice Maker (shown here with cover off)

The unit uses an ice maker that consists of a mold
heater, thermostat, motor, and wire harness. The
ice maker always starts from and stops at the "park"
position. In the park position (the ejector blades
are pointing horizontally towards the back of the
ice maker). Just before reaching the park position
the mold is filled with water. At the park position
all electrical components are de-energized, even
though the shut-off arm is down, and the ice maker
is ready for the next freeze cycle. The ice maker
takes from 30 minutes to one hour to freeze the
water. The primary time factors are the temperature
in the freezer and the amount of airflow around the
ice maker. Colder freezer settings and free air space
around the ice maker to let air circulate will help
make ice faster. After the ice forms, the ice maker
continues to wait until it reaches 15ºF before it
starts the harvest cycle. This ensures that the ice
is solid in all the cavities. At 15ºF the thermostat
closes, the mold heater turns on, and the ejector
blades rotate up and forward until they stall out
against the ice. The motor is designed to stall out
and is geared to generate a lot of pressure. This
minimizes the amount of melting needed to extract
the ice. As soon as the ice is loose enough to move,
the ejector pushes the ice out of the mold during the
second half of the first revolution. During the second
revolution, the ejector pushes the ice into the bucket.
42