Table of Contents
Advertisement
Freezer
(VFI/FFI/MVFI/VFFI models)
Wire Shelf Adjustment
You can easily adjust your freezer's shelves. To remove a shelf, simply tilt it up at the front,
releasing the hooks from the shelf support. Then, pull the shelf straight out. To replace, guide
the rear hooks of the shelf into the slots in the shelf supports. Then, tilt the shelf up at the front
until the hooks drop into the slots. Next, lower the front of the shelf to a level position.
Automatic Ice Maker
The ice maker is located above the upper freezer drawer on the left hand side.
After the refrigerator reaches normal temperature, the ice maker fi lls with water and
begins operating.
Note: Allow 24 to 48 hours after installation before looking for ice in your ice drawer.
You should discard the fi rst three full drawers of ice produced by your refrigerator,
and should also throw out the fi rst drawer full of ice your refrigerator produces after
extended periods of non-use.
During ice production, the ice maker arm raises and lowers. When the ice bin is full, the
ice maker arm automatically turns the ice maker off . To manually stop ice production,
raise the ice maker arm. You will hear a defi nite click when you have the arm in the right
position. The ice maker won't produce any more ice until you lower the ice maker arm.
CAUTION
To avoid damage to ice maker, observe the following:
• DO NOT force ice maker arm down or up past stop position.
• DO NOT place or store anything in ice bucket.
Ice Bin Removal
To remove the ice bin, pull top freezer drawer open. Raise
handle and pull up. When replacing the ice bin, lower
handle before closing drawer.
Handle down
10
On
Position
Ice Maker
Arm
Off
Position
Handle up
Advertisement
Table of Contents
