Refrigerator Temperature Sensor; Vegetable/Meat Temperature Control - Viking RDDFF236 Service Manual

Service Diagnostics and procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Refrigerator Temperature Sensor

The unit uses a Thermistor(NTC - Negative
Temperature Coefficient)) to sense refrigerator
temperature.
To access temperature sensor:
1. Open doors and remove shelves.
2. Remove control board housing (see Control
Board section, Steps 1-4, page 31).
3. Disconnect temperature sensor from control
board housing.
4. Replace or repair as necessary.
5. Reverse procedure to reinstall.
© 2012 Viking Preferred Service
WARNING

vegetable/Meat Temperature Control

The unit has a slide control to regulate air flow into
the vegetable/meat drawer.
To access vegetable/meat temperature control:
1. Open doors and remove shelves and drawers.
2. Lift up on right tray guide to disengage from
Temperature
Sensor
3. Rotate right tray guide to disengage clips, then
4. Repair or replace as necessary.
Meat/Vegetable
Temperature Control
inner wall.
remove temperature control and right tray guide.
Clip
32