HYOSUNG GT250 REi Owner's Manual page 37

② ②
FRONT BRAKE LEVER
The front brake is applied by squeezing
the brake lever gently toward the throttle
grip.
Front brake be anxious about motorcycle
falling down when braking suddenly as disk
brake system. The brake lamp will come on
when the lever is squeezed.
WARNING
Apply the brake lightly and with great
care on slippery surfaces to avoid
skidding.
③ ③
THROTTLE GRIP
Engine speed is controlled by position of
the throttle grip. Turn it toward you to
increase engine speed. Turn it away from
you to decrease the engine speed.
WARNING
Avoid turning the throttle grip during
brakes.
4 4 - - 1 1 HAZARD WARNING SWITCH
~ ~ For 『 『
『 『
⊙ "
" : All four turn signal lamps and
indicator lamp will flash
simultaneously when the
switch is turned on with the
ignition switch in "ON" position.
⊙ "
" : The turn signal lamps and
indicator lamp go off.
Use the hazard warning switch to warn
other traffic during emergency parking or
when your motorcycle could otherwise
become a traffic hazard.
』 』 &
』 』 ₩ ₩
Put out the hazard warning switch
directly after used.
If the motorcycle ride with the hazard
warning switch turned on condition,
other driver confuse and the battery's
service life is shortened as electrical
consumption.
The 『 『
always come on the head lamp, meter
lamp, tail lamp and license plate lamp
when the ignition switch was turned to
the "ON" position.
4 4 - - 2 2
LIGHT SWITCH
~ ~ Only for『 『
⊙ "
" position
: The head lamp comes on.
⊙ "
" position
: The meter lamp, tail lamp and license
plate lamp come on.
But, the head lamp not come on.
⊙ "
" position
: All lamps go off.
N O T E
The 『 『
operating the light switch turning the
ignition switch to the "ON" position.
36 36
CAUTION
CAUTION
』 』 & 『 『
』 』 ₩ ₩
』 』 's lamps are come on by
』 』