Ir Emitters - Russound CP 4.6 Instruction Manual

IR EMITTERS

The CP 4.6 has seven IR outputs: Source
1–6 and Common. Source 1–6 outputs
are source-specific and provide IR signals
only to the selected source; the Common
output provides IR signals to all sources.
Source-specific IR outputs (Figure 15) are
useful when a system has two or more of
the same model source component,
allowing you to target the IR commands
to each individual component.
To connect multiple emitters to the
Common IR output, use the Russound
847 connecting block and a 1/8-inch,
2-conductor (mono) phone plug as
shown in Figure 16. Wire the tip of the
phone plug to the signal terminal of the
847 and the sleeve to the ground termi-
nal of the 847.
Figure 15 – Source-specific infrared outputs
Figure 16 – Common infrared output
TIP
SLEEVE
1/8" (MONO)
PHONE PLUG
STRIPE WIRE
IS SIGNAL
(WIRES TO TIP)
Peripheral Devices
845.1 MICRO EMITTERS TO
IR RECEIVER WINDOW
OF SOURCE EQUIPMENT
RUSSOUND #847
CONNECTING BLOCK
RUSSOUND #845.1 MICRO EMITTERS
TO IR CONTROLLED EQUIPMENT
SOURCE 2
SOURCE 1
15