Pr-4Z Ir Emitter Outputs - Russound PR-4Z Instruction Manual

P
ERIPHERAL

PR-4Z IR EMITTER OUTPUTS

The PR-4Z has 5 IR emitter outputs located on the rear
panel: Zone 1, Zone 2, Zone 3, Zone 4 and Common. The
Zone 1-4 outputs provide IR signal out from their respective
zones, while the Common output provides IR signal output
for all zones. The Common output would most likely be used
most often to control source equipment, such as CD players
etc.. The Zone 1-4 outputs can be used to control IR control-
lable equipment which is proprietary to a particular zone ie.
IR controlled drapes, zone specific sources, etc.
Figure 23 – Zone Specific Infra-Red Outputs Using Single
Emitters
CMN 1 2 3 4
IR
OUT
14
D
EVICES
#845 MICRO EMITTER TO
IR RECEIVER WINDOW
OF ZONE 1 EQUIPMENT
Figure 24 – Common Infra-Red Output Connections Using
#847 Connecting Block as an Emitter Expander
CMN 1 2 3 4
IR
OUT
TIP
SLEEVE
1/8" (MONO)
PHONO PLUG
WIRE WITH
STRIPE IS SIG
To connect multiple emitters to a single IR output, use
Russound Model# 847 connecting block and an 1/8" 2 con-
ductor (mono) phone plug as shown in Figure 24. Wire the
"tip" of the phone plug to the signal terminal of the #847
and the " sleeve" to the ground terminal.
#847 CONNECTING BLOCK
#845 MICRO EMITTERS
TO IR CONTROLLED
EQUIPMENT