Connecting Wires To Terminals - JVC KW-V620BT Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection

Connecting wires to terminals

USB terminal (1.0 m):
Pages 62 – 63
Pages 62 – 63
Connect the antenna
cord to the antenna
terminal.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Power antenna wire)
Blue with white stripe (Remote output wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
1
Page 63* Page 64 Pages 62 – 63
(POWER ANTENNA)
(REMOTE OUTPUT)
(STEERING WHEEL REMOTE)
REVERSE
Purple with white stripe
(Reverse sensor wire)
PRK SW
Light green
(Parking sensor wire)
10 A fuse
Connect SiriusXM Connect Vehicle Tuner
1
(commercially available).* (Page 63)
2
*
To automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
To the OE remote adapter matching your car
To car light control switch
(ILLUMI)
(ACC)
(BATT)
(GND)
Connect to the vehicle's reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle's parking
brake detection switch harness.
3
• For best safety, be sure to
connect the parking sensor.
* 1 Only for KW-V620BT Region 1.
* 2 If no connections are made, do not let the cable come out from
the tab.
Ignition key switch
To car chassis
Fuse box
Battery
ENGLISH 61