Connecting Wires To Terminals - JVC KW-V41BT Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection

Connecting wires to terminals

See page 45.* 1
10 A fuse
See page 45.*
1
See page 45.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Power antenna wire)
Blue with white stripe (Remote output wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
44
USB terminal (0.8 m): See page 45.*
See page 45.
Connect the antenna cord to the antenna terminal.
Purple with white stripe
(Reverse sensor wire)
Light green (Parking sensor wire)
*
3
To automatic antenna if any (250 mA max.)
(POWER ANTENNA)
To the remote lead of other equipment (200 mA max.)
(REMOTE OUTPUT)
To the OE remote adapter matching your car
(STEERING WHEEL REMOTE)
To car light control switch
(ILLUMI)
(ACC)
(BATT)
(GND)
* Only for KW-V41BT/KW-V21BT.
1
2
* Only for KW-V41BT.
2
* If no connections are made, do not let the cable come out from the tab.
3
Connect to the vehicle's reverse lamp harness when using
the optional rear view camera.
Connect to the vehicle's parking
3
brake detection switch harness.
• For best safety, be sure to
To car chassis
connect the parking sensor.
Ignition key switch
Fuse box
Battery