CAME STYLO ME Installation Manual page 3

devices (i.e. transmitters) or any control devices away from children
as well, to prevent the operator from being activated accidentally •
Frequently check the system, to see whether any anomalies or si-
gns of wear and tear appear on the moving parts, on the component
parts, on the securing points, on the cables and any accessible con-
nections. Keep any joints (i.e. hinges) lubricated and clean, and do the
same where friction may occur (i.e. slide rails) • Perform functional
tests on photocells and sensitive edges every six months. To check
that the photocells work, pass an object in front of them during clo-
sing. If the operator reverses the direction of movement or comes to
a halt, the photocells work correctly. This is the only maintenance
operation that must be carried out while the operator is live. Ensure
that the glass on the photocells is kept clean (use a cloth slightly
moistened with water; do not use solvents or any other chemicals
as these could damage the devices) • If the system requires repairs
or modifi cations, release the operator and do not use it until safe-
ty conditions have been restored • Cut off the power supply before
releasing the operator for manual openings and before any other
operation, to prevent dangerous situations. Read the instructions •
Users are STRICTLY FORBIDDEN from performing OPERATIONS NOT
EXPRESSLY REQUIRED AND STATED in the manuals. For repairs,
adjustments and extraordinary maintenance, CONTACT THE SPECIA-
LIST TECHNICAL SERVICE CENTRE. On the periodic maintenance log,
note down the checks you have done.
Special instructions and advice for all
• Avoid working near the hinges or moving mechanical parts • Stay
clear of the gate's area of operation when in motion • Do not re-
sist the direction of movement of the gate; this may present a safety
hazard • At all times be extremely careful about dangerous points
The data and information provided in this manual are subject to change at any time without prior notice.
that must be indicated by proper pictograms and/or black and yellow
stripes • When using a selector or command in 'hold-to-run' mode,
keep checking that there are no people in the area of operation of
the moving parts. Do this until you release the command • The gate
may move at any time without warning • Always cut the power when
cleaning or performing maintenance.