Read Carefully - CAME STYLO ME Installation Manual

Foreword
• This product should only be used for the purpose for which it was
explicitly designed. Any other use is considered dangerous. CAME
S.p.A. is not liable for any damage resulting from improper, wrongful
or unreasonable use • Keep these warnings with the installation and
use manuals issued with the automation system.
Before installing
(preliminary check: in case of a negative outcome, do not proceed
until you have complied with the safety requirements)
• Check that the part you intend to automate is in good mechanical
condition, balanced and aligned, and that it opens and closes pro-
perly. Make sure that proper mechanical stops are already in place •
If the operator will be installed at a height of less than 2.5 m from the
ground or other access level, check whether you will need any pro-
tections and/or warnings • Any gate leaves fi tted with pedestrian en-
trances onto which you will install an operator must have a blocking
mechanism when the gate is in motion • Make sure that the opening
of the automated gate is not an entrapment hazard as regards any
surrounding fi xed parts • Do not mount the operator upside down
or onto any elements that may fold under its weight. If needed, add
suitable reinforcements at the points where it is secured • Do not
install onto gates not on level ground • Check that any lawn watering
devices will not wet the operator from the bottom up.
CAUTION!
important personal safety instructions:

READ CAREFULLY!

The data and information provided in this manual are subject to change at any time without prior notice.
Installation
• Carefully section off the entire site to prevent unauthorised access,
especially by minors and children • Be careful when handling ope-
rators that weigh more than 20 kg. In such cases, use proper weight
handling safety equipment • All opening commands (e.g. buttons, key
selector switches, magnetic detectors etc.) must be installed at least
1.85 m from the gate's area of operation perimeter - or where they
cannot be reached from the outside of the gate. Also, the direct com-
mands (buttons, touch commands etc.) must be installed at a height
of at least 1.5 m and must not be accessible to the public • All 'hold-
to-run' commands must be placed where the moving gate leaves,
transit areas and driveways are completely visible • If missing, apply
a permanent label that shows the position of the release mechanism
• Before delivering to the user, check that the system is EN 12453
(impact test) standard compliant. Make sure that the operator has
been properly adjusted and that the safety and protection devices as
well as the manual release are working properly • Where necessary
and in plain sight, apply the Warning Signs (e.g. gate plate)
Special instructions and advice for users
• Keep the gate's area of operation clean and clear of any obsta-
cles. Check that there is no vegetation in the area of operation of the
photocells and that there are no obstacles in the area of operation of
the operator • Do not allow children to play with the fi xed command
devices, or in the gate's area of operation. Keep any remote control