Turn On The Recorder; Turn On The Power Of The Recorder - Panasonic WJ-NV300K Installation Manual

Turn on the recorder

Turn on the power of the recorder

Turn on the power of the recorder. When using the recorder for the first time, register the license for the recorder. (☞ Page 36)
Step 1
Connect the provided power cord to the power cord inlet on
the rear panel of the recorder, and insert the power plug to
an outlet whose rating is as follows.
WJ-NV300K: 120 V AC, 60 Hz
WJ-NV300K/G: 220 V - 240 V AC, 50 Hz/60 Hz
The [OPERATE] indicator will light, the system check of
→ →
the recorder and the hard disk drives will start, and the
startup window will be displayed on the main monitor.
Important:
• Never turn off the power of the recorder during startup.
Note:
• If the license for the recorder has not been registered
yet, the message asking you to register the "Registration
Key" will be displayed.
34
Step 2
If the "Registration Key" for the recorder has not been regis-
tered yet, register the "Registration Key" by following the
procedures on page 36.
Note:
• When the "Login" window is displayed during operation
after startup, enter the user name and password. Refer
to the Operating Instructions (PDF) for descriptions of
how to operate.
• The default administrator name and password are as fol-
lows.
Administrator name : ADMIN
Password
• If the "Registration Key" for the recorder is once regis-
tered, the message asking you to register the
"Registration Key" will not be displayed from the next
time.
: 12345