Wimax Settings - Cradlepoint COR IBR1100/IBR1150 Manual

Highly available, cloud-managed networking for extreme conditions

page of 162

/ 162
Contents
Table of Contents
Bookmarks

Table of Contents

Auto (all modes): Let the modem decide which network to use.

Auto 3G (3G or less): Let the modem decide which 2G or 3G network to use. Do not attempt to connect to LTE.

Force LTE: Connect to LTE only and do not attempt to connect to 3G or WiMAX.

Force WiMAX: Connect to WiMAX only and do not attempt to connect tot 3G or LTE.

Force 3G (EVDO, UMTS, HSPA): Connect to 3G network only.

Force 2G (1xRTT, EDGE, GPRS): Connect to 2G network only.

Network Selection Mode: Wireless carriers are assigned unique network identifying codes known as PLMN (Public Land Mobile Network). To manually select a particular

carrier, select the Manual radio button and enter the network PLMN. Choose from the following options:

None/No Change

Auto: Selected by default

Home only

Manual: Input the PLMN code

Functional Mode: Selects the functional mode of the modem. IPPT (IP passthrough) mode causes the modem to act as a transport, passing Internet data and IP address

information between the modem and the Internet directly. NAT mode causes the modem to NAT the IP address information. Consequently, IPPT mode does not allow user

access to the modem web UI and NAT mode does allow user access to the modem web UI.

None/No Change

IPPT

NAT

Network-Initiated Alerts: This field controls whether the Sprint network can disconnect the modem to apply updates, such as for PRL, modem firmware, or configuration

events. These activities do not change any router settings, but the modem connection may be unavailable for periods of time while these updates occur. The modem may also

require a reset after a modem firmware update is complete.

Disabled: The request to update will be refused.

When Disconnected: The request to update will only be performed when the modem is either in a disconnected state or dormant state. If the modem is not in

one of these states when the request is received, then the router will remember the request and perform the update when the modem becomes

disconnected/dormant.

On Schedule: The request to update will only be performed at the specified scheduled time, no matter what the state of the modem is.

Network-Initiated Schedule: When you select "On Schedule" for Network-Initiated Alerts, you also select a time from this dropdown list. Modem updates will

take place at this scheduled time.

AT Config Script: Enter the AT commands to be used for carrier specific modem configuration settings. Each command must be entered on a separate line. The command

and associated response will be logged, so you should check the system log to make sure there were no errors.

NOTE: AT Config Script should not be used unless told to do so by your modem's cellular provider or by a support technician.

AT Dial Script: Enter the AT commands to be used in establishing a network connection. Each command must be entered on a separate line. All command responses must

include "OK", except the final command response, which must include "CONNECT".

Example:

ATDT*99***2#